Information

DIESEL ON HHO

we work with putting HHO on diesels of all sizes and so far have had great success.

Website: http://Blakesystemsinc.com
Location: USA
Members: 91
Latest Activity: May 18

Discussion Forum

2.7 Turbo diesel

Started by hydrosmith. Last reply by flyingdoc Oct 6, 2011. 14 Replies

Turbo diesels and HHO

Started by Grasack. Last reply by flyingdoc Oct 4, 2011. 4 Replies

Putting the HHo on a deisel

Started by Dennis Henderson. Last reply by Jeremy Dukes Aug 28, 2011. 18 Replies

Comment Wall

Comment

You need to be a member of DIESEL ON HHO to add comments!

Comment by mrpaul on April 22, 2009 at 7:46pm
HHO is not just HHO. There is two types of hydrogen that I know of. Para Hydrogen is like high test gas and Ortho is like regular grade gas. I'm going to get some comments on that one. Anyway SSN is Ortho and that's all I can tell you. I am doing research on it now. I'll let you know more when I know more.
Back to restrictive air flow. On a gas engine that's fine but your messing with the health of a diesel engine when you try that with them.
I hope I didn't open a can of worms. Tune in tomorrow for more.
Comment by Christer Dirfeldt on April 22, 2009 at 12:25pm
I have at least noticed that the mileage drop when I restrict the airflow too much.

Paul, when you mean quality of HHO what do you mean by that? Isn't HHO HHO?
Comment by Paul M. on April 22, 2009 at 11:32am
I don't know if when you did your test the cell unit and reservoir were at operating temperature. If the unit is cold when you do a test it needs to be warm, so a 10 mile test is not enough. If you don't have a pwm, now is a good time to get one. What that will do is help you with city driving and mileage results. When you start up cold, the pwm will bring your unit up to operating amps without having to wait for it to warm up, so you start gaining right away. As far as restricked air flow I would highly recommend against that practice on a diesel. When you restrict on a diesel you build heat in engine and especially in the turbo if you have one. Heat will absolutely kill your turbo bearing and you will experience catastrophic failure. With a diesel there is more to the quality of hho than the quantity.
Comment by Christer Dirfeldt on April 13, 2009 at 6:05pm
I assume that I get best results with only water, I have to stop posting here?
Comment by Christer Dirfeldt on April 13, 2009 at 4:18pm
Oh, does it have an oxygen sensor? When I asked the VW dealer, they said it doesn't.

But anyway I filled up today and got better mileage again, actually better than last time with results, 56MPG (US measure), and the cell had drawn less and less amps also, so the cell didn't produce much gas or steam when I tested it before filling up.

It might be watervapour that are sucked in, just as Fozzy has claimed helps. I will now test with my simple humidifier instead and see if that can give me results.
Comment by Hydrotinkerer on April 13, 2009 at 11:02am
The 95 vw-tdi has an oxygen sensor and an airflow meter. It is a common rail diesel and computer controlled.
Comment by Christer Dirfeldt on April 11, 2009 at 5:16am
It is a1,9 tdi.

I am not sure about the computer. I got worse mileage this time, but I had the engine running at idle much when I tested the system and I also had restricted the airflow with a tubesock(!), that I should use later on as a humidifier. And it was much short 5-10 min trips.
Comment by gary mbz (hho boost now) on April 11, 2009 at 12:22am
what size diesels are you using ?and does the tdi computer interfere ? we build them for class 8 trucks @ www.hhoboostnow.com and i am building a smaller new one for my benz .keep up the good work
Comment by Christer Dirfeldt on April 9, 2009 at 7:23pm
I have just got an increase on my VW tdi passat -95. And what worked was not a supereffective giant cell, but a very ineficcient 2 plate cell, that creats heat as well, lots of heat. I got an increase in mpg of 20%, and i think that the hot steam in addition to HHO is the key.
 

Members (91)

 
 
 

*** Translate HODINFO ***

Latest Activity

Jediah Krajcik updated their profile
Thursday
Aaron Malczewski replied to DAN MERRICK's discussion 'hhhn vs hho'
Thursday
Wade Waters replied to Felix Audet's discussion 'Resonnance electrolysis VS HV flyback'
Wednesday
Jediah Krajcik is now a member of HODINFO
Aug 9
charles ware replied to charles ware's discussion 'Popular mechanics story on HHO'
Aug 2
Richard Keough updated their profile
Jul 31
Profile IconKiera and Clare Katz joined HODINFO
Jul 31
broandrew replied to charles ware's discussion 'Popular mechanics story on HHO'
Jul 30
Alan Smith replied to gabet123's discussion 'Harlo Mayne and Maynex'
Jul 25
gabet123 posted a discussion
Jul 25
gabet123 commented on David Brightman's status
Jul 24
Stuart Kinley joined James Morehead's group
Jul 23
David Brightman commented on David Brightman's status
Jul 22
gabet123 commented on David Brightman's status
Jul 22
David Brightman posted a status
". enough clearance between the electrodes as I cell I found a fine slurry of cast iron had bridged the regards Dave"
Jul 21
Heidi Dayne Hanson is now a member of HODINFO
Jul 17

© 2018   Created by gabet123.   Powered by

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

Live Chat