Comment

Comment by Daniel Donatelli Secure Supplies on July 14, 2014 at 6:29am

Hello , Nice Group, I want to draw your Attention to several things have 

1 Stan Meyer Circuits for Bench top unit wet cell Original Spec with Chokes Done

   www.irondmax.com forum  tellem Dan invited you

2 Fuel Line Live Monitor to 3g along with Engine Vitals live and Cloud Management platform Done and Available. 

3 ECu to unlock the car full potential and android tablet tuning DONE

4 Quality Split gas Cell 24 4 amp runs 24 hrs Done connect to ECU. 

I am Looking to expand Country Dealer /resellers and Installer partner at this time

I invite professionals in Business to contact me directly to discuss. 

www.securesupplies.biz

danieldonatelli@hotmail.com 

Comment by David Bixler on May 8, 2011 at 12:57pm

hey everyone, I added many never before seen pictures of Stan Meyer's stuff. (vic's and other resonance stuff) to my page.

Comment by Zip on November 29, 2010 at 6:14pm

Hi there. Anyone has an effective, over the average setup in here?

Comment by Richard Collins on October 2, 2010 at 5:05pm

I have been adding new content to the Meyer Research Group. If you research Meyers work then please join that group as well.

Comment by hho man 2.7 on March 11, 2009 at 5:06pm

this blog is going no were.has any one dun any new experiments

Comment by James Morehead on February 6, 2009 at 12:00am

Where did gadgetman get this info from?

Comment by don on February 5, 2009 at 3:21pm

I just discovered they're using 13.56 MHz for the Stan Myers device...
this was presented to me by gadgetman trying to find out more?

Comment by hho man 2.7 on February 4, 2009 at 3:18pm

well i melted my sell down to day.but i did learn that when useing a dry cell your out put hose should never get below the out put port.i had my out put hose propt up so it didnt go below the out put port but the roll of tape i used to prop it up fell over lasnite and the hose whas laying on the tabel witch in tern stoped the flow of electrolyte thrue my cell and it got hot enough to melt my cutting bord ends.also my iner tube gaskets stood up really well it never hurt the gaskets a bit.

Comment by hho man 2.7 on February 2, 2009 at 7:30pm

hi every one im new to this group and just wanted to say hi.i have a 2x2.75 +nnnnn- dry sell it is run in and runing good. it is runing at 3.5amp on koh.im setting up for resonance testing and i am building a bigger sell.

Comment by Slaven on January 22, 2009 at 9:54am

My dad finally brought some obsolete tubes from his company so I can finally start some calculations !

• ‹ Previous
• 1
• 2
• Next ›
• Page