HODINFO SPONSOR
javier sanchez
  • aguilas , murcia
  • Spain
Share Twitter

Javier sanchez's Friends

  • Francisco Rodriguez
  • jay settle
  • Barry Holzsweig
  • don
  • gabet123

javier sanchez's Groups

javier sanchez's Discussions

injection correction problem with long term and short term

Hello again everyone,This morning I have been setting my opel zafira 1.6 liter, 2005.everything seems fine, control cts, control iat (about 30 degrees more than it is), control maf (10% less),…Continue

Started Mar 3

Anyone know this company?

Hello everyone, I mean greensource.ca and products.can not find anyone who has opinions that sell kits.do not know if anyone has tried the ProKit ProKit 12 and 13, the price seems right but not the…Continue

Started Feb 12

how can this be?
8 Replies

hello all and Merry Christmas for a while I see being installed here in Spain about hho generators very primitive design. a mmw 1, produces 80 ml ​​/ min for one minute hho to 12 volts and 5 amperes…Continue

Started this discussion. Last reply by javier sanchez Jan 31.

o2 sensor voltage
2 Replies

Hi, I have a big question, usually with o2 sensors when the mixture is rich due to lower voltage (I think this is correct) but today I passed a rarity. I measured the black wire probe (zirconium…Continue

Started this discussion. Last reply by javier sanchez Sep 30, 2012.

 

javier sanchez's Page

Latest Activity


HODINFO SPONSORjavier sanchez posted a discussion

injection correction problem with long term and short term

Hello again everyone,This morning I have been setting my opel zafira 1.6 liter, 2005.everything seems fine, control cts, control iat (about 30 degrees more than it is), control maf (10% less), upstream efie ofset 100 millivolts (negative correcion is where most will do), efie after the catalyst (230 millivolts ofset), dry cell 13 plates, 7 amps.This is the current setup and driving at cruising speed on the motorway with the scanner connected I see a very rare thing:injection corrections…See More
Mar 3
0 Comments

HODINFO SPONSORjavier sanchez posted a discussion

Anyone know this company?

Hello everyone, I mean greensource.ca and products.can not find anyone who has opinions that sell kits.do not know if anyone has tried the ProKit ProKit 12 and 13, the price seems right but not the quality and duration of these generators.I send an email to green source explained to me as are the generators and distribution of electrodes, but they said that they are not going to say this.it can be either very good or very bad "you are saying?See More
Feb 12
0 Comments

HODINFO SPONSORjavier sanchez replied to javier sanchez's discussion 'how can this be?'
" "
Jan 31
moldoveanu.marius replied to javier sanchez's discussion 'how can this be?'
"I agreed with injection point. For turbo or superchaded engines a venturi device should solve the problem ( wait for one now to test it). Still do not get an answer : what make the difference between a mixture of H2/O2 and so call HHO ? I think is…"
Jan 31
Barry Holzsweig replied to javier sanchez's discussion 'how can this be?'
"Javier, Just now reading your post. The two electrodes (bolts) are producing mostly H2 and O2 and a small amount of HHO. The cell you have with 9 plates is producing mostly HHO and small amounts of H2 and O2. These two mixtures behave differently in…"
Jan 30

HODINFO SPONSORjavier sanchez replied to javier sanchez's discussion 'how can this be?'
"I think if this cold wet cell will not make steam, but you can see a white smoke is steam koh.dry cell does the same, maybe the problem is given the wet cell leakage current."
Jan 26
Mike Walsh replied to javier sanchez's discussion 'how can this be?'
"I'm thinking that the greater benefits seen from the simple electrolyzer are due to higher volumes of water vapor present in the gaseous output. I've also seen simple wet cells out perform dry cells for this reason."
Jan 26
moldoveanu.marius replied to javier sanchez's discussion 'how can this be?'
"Commonrail turbodiesel engine was very well responsive to wet oxyhydrogen at my last test. Again, not at idle. The load required by the electrolytic cell increase injection time. On road the torque was higher and driving at that regime where most…"
Jan 8
Kikox1 replied to javier sanchez's discussion 'hcs, fuel cracking system'
"In this link  https://www.facebook.com/groups/121433801328438/ there is more information over this system using a copper tube to heat, there is documents in docx formats for installation and more."
Jan 7

HODINFO SPONSORjavier sanchez replied to javier sanchez's discussion 'how can this be?'
"marius very responsive friend, but now I have my head in a mess; koh vapor is water vapor different from normal, I mean that in a cold hose 4 feet or more I have noticed that white steam continues to escape (this is good looking in a black…"
Jan 5
moldoveanu.marius replied to javier sanchez's discussion 'how can this be?'
"Two electrodes mean 13.5-13.8 Volts per cell. 60-70 W at 5 A It must rise the water temperature and produce some steam. Alkaline steam - due KOH. KOH may react on manifold with incoming CO2 ( from air ) and form a bicarbonate salt that deposit…"
Jan 4

HODINFO SPONSORjavier sanchez replied to GEORGE MATHIOUDAKIS's discussion 'HELP'
"I had understood that the HHO is three times more potent than h2."
Dec 25, 2012

HODINFO SPONSORjavier sanchez posted a discussion

how can this be?

hello all and Merry Christmas for a while I see being installed here in Spain about hho generators very primitive design. a mmw 1, produces 80 ml ​​/ min for one minute hho to 12 volts and 5 amperes and the electrolyte is KOH.   one of these is preferred equipment for motors up to 2.5 liters in size. only has two electrodes 316 l round bar with a gap of 2.5 inches between them. I do not understand but they work, I've tried it on some vehicles and get between 15 and 30% savings especially in…See More
Dec 25, 2012
8 Comments

HODINFO SPONSORjavier sanchez replied to GEORGE MATHIOUDAKIS's discussion 'HELP'
"hello, and Merry Christmas to all,I think the best option is to add a small amount of HHO to mix with the incoming air to the boiler.but for a boiler that consumes 50 liters of diesel may need at least 20 lpm of hho.the danger of working with large…"
Dec 25, 2012

HODINFO SPONSORjavier sanchez replied to javier sanchez's discussion 'my new car'
"good morning from Spain Ivaldo, thank you very much for your input, it's funny but I use an additive for motor oil that is made up of "molybdenum disulfide."you say to use molybdenum sulfide, but I do not know the electrical…"
Nov 8, 2012
Ivaldo Amorim replied to javier sanchez's discussion 'my new car'
"Hello Javier and staff of this forum is so important for all of us, very good night! I want everything to be at peace with friends and family. This is my first post on this forum and wish to collaborate, to the extent possible, with my basic…"
Nov 7, 2012

Profile Information

What is your HOD level of experience?
Novice Builder

Comment Wall

You need to be a member of HODINFO to add comments!

Join HODINFO

  • No comments yet!
 
 
 

Translate HODINFO

Fuel Savers Radio Podcast

December 15, 2012

December 8, 2012

Latest Activity

Profile IconHydrogen Cars and Vehicles Blog

California to Receive 7 New Hydrogen Fueling Stations

Thursday

HODINFO SPONSORHoward Phillips commented on tan kusuma's video
Thumbnail

ZCLC on Traditional Fisherman's Boat Day #1 with 30 HP Diesel Engine

Wednesday
Profile IconHydrogen Cars and Vehicles Blog

SmartFuel Retail Hydrogen Dispenser Introduced by Air Products

Wednesday
Bo DuBose joined don's group
Thumbnail

experts only

Jun 11
3 Comments
gabet123 updated their profile
Jun 11
Profile IconHydrogen Cars and Vehicles Blog

BMW Develops Largest Fleet of Fuel Cell Forklifts in North America

Jun 11
Dale Drew joined Heath's group
Thumbnail

DIESEL ON HHO

Jun 11
88 Comments

HODINFO SPONSORJeremy Dukes posted a status
"tax benefits for those of us who have installed hho between '05-'10 on vehicles"
Jun 10
1 Comment
Rahul Kumar Rana updated their profile
Jun 9
moldoveanu.marius commented on Jaime 's photo
Thumbnail

image

Jun 9
Jaime posted photos
Thumbnail
Thumbnail
Thumbnail
1 more…
Jun 8
Profile IconHydrogen Cars and Vehicles Blog

Halogenated Graphene Nanoplatelets for Platinum-Free Fuel Cells

Jun 6
gabet123 replied to Matteo Monfardini's discussion 'New business in Italy'
Jun 6

HODINFO SPONSORHoward Phillips replied to gabet123's discussion 'Phillips Company CC-HOD Press release 3'
Jun 6
ocjox updated their profile
Jun 5
ocjox is now a member of HODINFO
Jun 5
Welcome Them!
Profile IconHydrogen Cars and Vehicles Blog

Nitrogen Doped Carbon Nanotubes Can Be Key Catalyst for Fuel Cells

Jun 5

HODINFO SPONSORHoward Phillips posted a discussion

How to reduce the cost of hydrogen production using CC-HOD?

Jun 4
0 Comments

HODINFO SPONSORHoward Phillips commented on gabet123's group 'Chemistry Group'
Jun 4
Tom Punch posted videos
Thumbnail
Thumbnail
Jun 4

© 2013   Created by gabet123.

Badges  |  Report an Issue  |  Privacy Policy  |  Terms of Service

Live Chat